[buddypress-trac] [BuddyPress] #3473: Multisite upgrade breaks existing active component settings.

[buddypress-trac at lists.automattic.com]

#3473: Multisite upgrade breaks existing active component settings.
----------------------+-----------------
 Reporter:  DJPaul    |      Owner:
     Type:  defect    |     Status:  new
 Priority:  normal    |  Milestone:  1.5
Component:  Core      |    Version:
 Severity:  critical  |   Keywords:
----------------------+-----------------
 On a clean install of trunk and WP 3.2.1 (no multisite), install BP and
 activate as usual, accepting all the defaults presented in the setup
 wizard. This will have the default page slugs created, and all the
 components active.

 Then enable your WP to run in multisite, by going through the normal
 WP_ALLOW_MULTISITE steps, etc. After the multisite is enabled, and you've
 logged back in re-enable BuddyPress network-wide, you'll get the Setup
 nag. Run through that process, again accepting the default page slug and
 component status.

 What should happen is that everything remains active, and page mapping
 associations are intact. Instead, the components all deactivate themselves
 with the exception of Site Tracking which we've just turned on again. Page
 mapping also appear to be broken. See screenshot.

-- 
Ticket URL: <https://buddypress.trac.wordpress.org/ticket/3473>
BuddyPress <http://buddypress.org/>
BuddyPress